This patch enables switch auto-detction for mt7981 as some new mt7981
boards will use AN8855 ethernet switch.
Signed-off-by: Weijie Gao <weijie.gao@mediatek.com>
Move gpio-controller up to pinctrl node and rename label to "pio" to
match the label used in upstream kernel linux.
Update any DTS that reference the pinctrl to follow the new naming and
structure.
Signed-off-by: Christian Marangi <ansuelsmth@gmail.com>
Reviewed-by: Weijie Gao <weijie.gao@mediatek.com>
Tested-by: Weijie Gao <weijie.gao@mediatek.com>
This patch adds pwm channel 2 (pwm3) support for mt7981
Signed-off-by: Sam Shih <sam.shih@mediatek.com>
Signed-off-by: Weijie Gao <weijie.gao@mediatek.com>
Explicitly add quad mode capabilities or the SPI controller may
start transfer in single mode.
Signed-off-by: SkyLake.Huang <skylake.huang@mediatek.com>
Signed-off-by: Weijie Gao <weijie.gao@mediatek.com>
Now that individual 2.5Gbps SGMII support has been added to
mtk-eth, all boards that use 2.5Gbps link with mt7531 must be
converted to use "2500base-x" instead of "sgmii".
Signed-off-by: Weijie Gao <weijie.gao@mediatek.com>
Now we use fdtdec_setup_mem_size_base() to get DRAM base from fdt ram node
and update gd->ram_base. CFG_SYS_SDRAM_BASE is unused and will be removed.
Also, since mt7622 always passes fdt to linux kernel, there's no need to
assign value to gd->bd->bi_boot_params.
Signed-off-by: Weijie Gao <weijie.gao@mediatek.com>
This patch adds general board files based on MT7981 SoCs.
MT7981 uses one mmc controller for booting from both SD and eMMC, and the
pins of mmc controller are also shared with spi controller.
So three configs are need for these boot types:
1. mt7981_rfb_defconfig - SPI-NOR and SPI-NAND
2. mt7981_emmc_rfb_defconfig - eMMC only
3. mt7981_sd_rfb_defconfig - SD only
Reviewed-by: Simon Glass <sjg@chromium.org>
Signed-off-by: Weijie Gao <weijie.gao@mediatek.com>
