For some reason the Ethernet PHY reset delay is set to 1 second, this
cause an unneccecery long boot delay.
MiQi use RTL8211 Ethernet PHY, datasheet list an initial 10ms delay and
then a 30-76ms delay before accessing registers.
Change to use 80ms delay instead of a full second to speed up Ethernet
initializion in U-Boot.
Also enable PHY_REALTEK, DM_ETH_PHY and PHY_GIGE to improve Ethernet PHY
support in U-Boot.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
Add bootph props and enable related Kconfig options to include the sdmmc
regulator in SPL. Also enable SPL_DM_SEQ_ALIAS to ensure aliases is
handled correctly in SPL.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
Add bootph- props to emmc, sdmmc, uart and related pinctrl nodes to
ensure devices and pinctrl can be used in xPL and U-Boot pre-reloc.
Remove the explicit bootph-all prop from the pinctrl node, any bootph-
prop will automatically be propagated to the pinctrl node.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
The work led is not used in xPL on rk3288-miqi, remove bootph props from
the work led node to exclude it from xPL control FDT.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
Sort the nodes in rk3288-miqi-u-boot.dtsi in alphabetical order.
This has no intended change to board DT, this only rearrange nodes in
preparation for future changes.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
In order to sync rk3288.dtsi from Linux it needed to
move all u-boot specific properties in separate dtsi files.
Signed-off-by: Johan Jonker <jbx6244@gmail.com>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
