On STi platforms, all clocks are enabled by BOOTROM, so CONFIG_CLK is
not set as no clock driver for STI exists.
As ehci-generic and ohci-generic drivers are used on platforms where
CONFIG_CLK is set, clk_get_bulk() returns-ENOSYS in case of
stih410-b2260.
To avoid this error, add fixed clocks for ehci and ohci nodes for
stih410-b2260 to fix the following errors:
Bus usb@9a03c00: ohci_generic usb@9a03c00: Failed to get clocks (ret=-19)
Port not available.
Bus usb@9a03e00: ehci_generic usb@9a03e00: Failed to get clocks (ret=-19)
Port not available.
Bus usb@9a83c00: ohci_generic usb@9a83c00: Failed to get clocks (ret=-19)
Port not available.
Bus usb@9a83e00: ehci_generic usb@9a83e00: Failed to get clocks (ret=-19)
Port not available.
scanning bus dwc3@9900000 for devices... 1 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
Signed-off-by: Patrice Chotard <patrice.chotard@foss.st.com>
Cc: Marek Vasut <marex@denx.de>
Reviewed-by: Patrick Delaunay <patrick.delaunay@foss.st.com>
Link: https://lore.kernel.org/r/20250130163547.512990-2-patrice.chotard@foss.st.com
Signed-off-by: Mattijs Korpershoek <mkorpershoek@baylibre.com>
A previous series already update STMicroelectronics emails maintainers
but some files have been omitted (Makefile, .dts, .dtsi and .rst files).
Update Patrick and my email address with the one dedicated to upstream
activities.
Signed-off-by: Patrice Chotard <patrice.chotard@foss.st.com>
Reviewed-by: Patrick Delaunay <patrick.delaunay@foss.st.com>
STiH410 has 2 PHYs wired on the DWC3 IP, USB2 and USB3 PHYs.
As currently no U-boot driver is available for the USB3 PHY and to avoid
issue during DWC3 drive probe, we use DWC3 IP with only USB2 PHY
using stih410-b2260-u-boot.dtsi file.
Fixes: 2fd4242cc50e ("ubs: xhci-dwc3: Enable USB3 PHY when available")
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
