Fix spelling mistake in the board init files of j721e and j721s2.
s/WKUP_DEVSTAT_MCU_OMLY_MASK/WKUP_DEVSTAT_MCU_ONLY_MASK
Signed-off-by: Prasanth Babu Mantena <p-mantena@ti.com>
Adaptive Voltage Scaling (AVS) Class 0 is a procedure for lowering the
voltage on certain device power rails. Initialize AVS Class 0.
Link: https://www.ti.com/lit/pdf/spruj28 (Section 5.2.3.3.2.5 AVS-Class0)
Signed-off-by: Manorit Chawdhry <m-chawdhry@ti.com>
Reviewed-by: Aniket Limaye <a-limaye@ti.com>
Enable Quality of Service (QoS) blocks for Display SubSystem (DSS), by
servicing the DSS - DDR traffic from the Real-Time (RT) queue. This is
done by setting the DSS DMA orderID to greater than 9.
Before setting up the QoS, the ORDERID needs to be mapped to VBUSM sources
using setup_navss_nb() function call that sets the threadmap for NBSS
registers. (Section 10.2.9.2.10 "Quality of Service" in TRM[0])
Section 3.2.1 "Quality of Service (QoS)" in the TRM[0] provide more
details.
[0]: https://www.ti.com/lit/zip/spruj28
Signed-off-by: Jayesh Choudhary <j-choudhary@ti.com>
This makes it clear these are only to be used by the R5 builds of SPL.
And this will be used to later more cleanly split the two builds.
Signed-off-by: Andrew Davis <afd@ti.com>
Currently each set of board targets from a vendor is selected inside
the board directory for that vendor. This has the problem of multiple
targets, one from each vendor, being selectable at the same time.
For instance you can select both TARGET_AM654_A53_EVM and
TARGET_IOT2050_A53 in the same build.
To fix this we need to move the target board choice to a common location
for each parent SoC selection. Do this in arch/arm/mach-k3.
Signed-off-by: Andrew Davis <afd@ti.com>
mcu_timer0 is used by u-boot as the tick-timer. Add it to the soc
devices lsit so it an be enabled via the k3 power controller.
Reviewed-by: Neha Malcom Francis <n-francis@ti.com>
Reviewed-by: Nishanth Menon <nm@ti.com>
Signed-off-by: Manorit Chawdhry <m-chawdhry@ti.com>
Add main_uart5 clocks in clk-data.c for J721S2. Now,
main_uart5 clocks will be set up while booting the J721S2 SoC.
Signed-off-by: Bhavya Kapoor <b-kapoor@ti.com>
Reviewed-by: Bryan Brattlof <bb@ti.com>
Add device data for main_uart5 in dev-data.c for J721S2. Now,
main_uart5 will be powered on while booting the J721S2 SoC.
Signed-off-by: Bhavya Kapoor <b-kapoor@ti.com>
Reviewed-by: Bryan Brattlof <bb@ti.com>
