mirror of
https://github.com/smaeul/u-boot.git
synced 2025-10-31 03:58:17 +00:00
a9afaa42ee
Align doc/device-tree-bindings/spi/spi-stm32-qspi.txt with kernel v5.2-rc6 Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
45 lines
1.3 KiB
Plaintext
45 lines
1.3 KiB
Plaintext
* STMicroelectronics Quad Serial Peripheral Interface(QSPI)
|
|
|
|
Required properties:
|
|
- compatible: should be "st,stm32f469-qspi"
|
|
- reg: the first contains the register location and length.
|
|
the second contains the memory mapping address and length
|
|
- reg-names: should contain the reg names "qspi" "qspi_mm"
|
|
- interrupts: should contain the interrupt for the device
|
|
- clocks: the phandle of the clock needed by the QSPI controller
|
|
- A pinctrl must be defined to set pins in mode of operation for QSPI transfer
|
|
|
|
Optional properties:
|
|
- resets: must contain the phandle to the reset controller.
|
|
|
|
A spi flash (NOR/NAND) must be a child of spi node and could have some
|
|
properties. Also see jedec,spi-nor.txt.
|
|
|
|
Required properties:
|
|
- reg: chip-Select number (QSPI controller may connect 2 flashes)
|
|
- spi-max-frequency: max frequency of spi bus
|
|
|
|
Optional property:
|
|
- spi-rx-bus-width: see ./spi-bus.txt for the description
|
|
|
|
Example:
|
|
|
|
qspi: spi@a0001000 {
|
|
compatible = "st,stm32f469-qspi";
|
|
reg = <0xa0001000 0x1000>, <0x90000000 0x10000000>;
|
|
reg-names = "qspi", "qspi_mm";
|
|
interrupts = <91>;
|
|
resets = <&rcc STM32F4_AHB3_RESET(QSPI)>;
|
|
clocks = <&rcc 0 STM32F4_AHB3_CLOCK(QSPI)>;
|
|
pinctrl-names = "default";
|
|
pinctrl-0 = <&pinctrl_qspi0>;
|
|
|
|
flash@0 {
|
|
compatible = "jedec,spi-nor";
|
|
reg = <0>;
|
|
spi-rx-bus-width = <4>;
|
|
spi-max-frequency = <108000000>;
|
|
...
|
|
};
|
|
};
|